Lesson 3

Week 3

After I had a complete surface of my face, I had to extrude it, so I selected the points in the vertical middle of the face and on the geometry tab I selected MAKE PLANAR , X. I went to the left view and keeping all the points selected dragged them out.

Then I just did the same with all other lines, following my face features from left view until my face was complete. I made it SEE THROUGH because it is easier to form.

Finished half of my face.

Followed tutorial:

http://www-personal.umich.edu/~emaslows/forums/training_videos/modeling/MAX_OMS-04_LineToSurface_p2.mov