Symmetry and Turbo-smooth

To make a copy of the half of the face, I chose a SYMMETRY from the modify panel and clicked FLIP. Then I was correcting some points on the face going back to editable poly.

Finally, from modify panel I selected TURBO-SMOOTH what made my complete face look smoothed.

Followed tutorial:

http://www-

personal.umich.edu/~emaslows/forums/training_videos/modeling/MAX_OMS-05_SymmetrySubD.mov

The next step was my nose. I left the big holes for special, so now I am returning to fix it.

By edge mode from editable poly I selected the edges following around the ''nose hole'' and by SCALE tool and holding SHIFT I extruded extra polygons. Then I made some corrections by CAT tool adding some extra lines and deleting useless polygons. Also I CONNECTED some lines to have more lines between them ( it will be shown on picture).

Then, to finish my nose I selected CREATE tool and drew 2 small polygons how it is shown on the picture, after what they were selected and drugged up to make them more inside the nose.

Followed Tutorial:

http://www-personal.umich.edu/~emaslows/forums/training_videos/modeling/MAX_OMS-06_RefineTechniques.mov